Page 49 of 51
(North America Edition)
©2019 Lytx, Inc. - Confidential & Proprietary.
Uninstalling the Device
If you must uninstall the device for any reason, follow the guidance and instructions below.
EXPLOSION HAZARD: Do not disconnect equipment unless power has been removed and
the area is known to be non-hazardous.
WARNING: Make certain that neither the cable nor your installation activities interferes
with any airbag-related mechanisms or otherwise risks affecting airbag deployment.
Consult the vehicle manufacturer for the location of any airbag sensors and systems
and restrictions that may apply.
CAUTION: Before proceeding, you may need to remove the window and door trim to
remove the cable underneath. These typically snap on and off using special clips. In
vehicles with side and curtain airbags, the clips are often one-time use and may need to
be replaced after removal. Please refer to the vehicle service manual for information.
CAUTION: Do not try to pull or pry the bracket off the windshield. Doing so may cause
damage to the windshield.
Materials
l
Torx wrench OR screwdriver with T-27 and T-8 Torx bits
l
3M Tape Removal Tool OR a broad, very thin putty knife
l
WD-40 OR a similar lubricant
Instructions
Before you begin, review the
"Electrical Connection Overview Diagram" starting on page 21
for a summary of the existing installation.
1. Turn off the vehicle ignition and remove the key.
2. Remove the screws on each side of the device. Detach the device from the bracket.
3. Remove the security screw and the Tamper Prevention Clip on the back.
