Lynxmotion UAV
HQuad500 Frame Assembly Guide
2.2 - Landing Gear Step-1
The landing gear is partially assembled here to have the motor wiring run inside the landing plate. It will not be bolted
to the clamps yet to help with the arm assembly on a flat surface.
Material Needed:
●
4x HQuad500 Tip Landing OR Wire Cap
●
4x Rubber Grommet
1.
Insert the rubber grommet in the hole landing OR cap.
Lynxmotion UAV HQuad500 Wire Grommet
2.
Run your motor wires inside the grommet and let the landing plate hang there until the step “2.7 Landing
Gear Step2”. We do not suggest to mount them on the frame at this step to be able to assemble the frame
on a flat surface.
Lynxmotion UAV
P.6
