Lynx RADIEN Crossover E-TEC Series, Operator'S Manual, Page: 187 / 283

MAINTENANCE PROCEDURES
-REMOVE
TETHER CORD
-LOOSEN BOLT
-ADJUST CLICKER
-TORQUE BOLT
( 7 @ 9 Nm )
( 62 @ 80 lbs in )
CLICKER ADJUSTMENT
1
2
3
4
& 2 4
LOWER RPM
( 1 & 2 )
HIGHER RPM
( 4 & 5 )
3
1
2
3
4
5
5
4
2
1
DEC-516009265-EN
Track
Track Condition
WARNING
Remove tether cord cap from engine cut-off switch before
performing any maintenance or adjustment, unless otherwise
specified. Vehicle must be parked in a safe place, away from
the trail.
Remove tether cord cap from engine cut-off switch.
Lift the rear of the snowmobile and support it with a wide-base snow-
mobile mechanical stand with a rear deflector panel. With the engine
off, rotate the track by hand, and inspect condition. If worn or cut, or
if track fibers are exposed, or if missing or defective inserts or guides
are noted; contact an authorized Lynx dealer.
S Snowmobiles Equipped with Traction Enhancing Products
If your snowmobile is equipped with a BRP approved studded track,
PROCEED WITH A VISUAL INSPECTION OF YOUR TRACK BEFORE
EACH USE.
Look for any defects, such as:
– Perforations in the track
_________________
185