C DX 5624 Reference Manual. Rev 2.0
The area at the bottom of the screen is the error log. Any fault condition will be
timestamps and entered into the log (as long as the controller / adapter is connected)
There are a number of Tabs associated with each Module which splits up the modules
settings into a number of separate screens. The various GUI screens and functions are
described below.
Main Tab
This screen is the main GUI interface and is presented first when the module is displayed
in the GUI. The layout replicates function and the signal flow if from left to right.
Selections are made using onscreen sliders, radio buttons, drop down selections and
checkboxes.
Input Detection
On the left the SDI input is detected and the format displayed on screen (in green)
Deembedder
The first stage is the audio deembedder. The four audio groups are represented by the
dark grey boxes and the individual audio signals within each AES channels are shown as
being present when highlighted green. This is a good reference for checking embedded
audio status on the incoming SD/HDTV SDI stream.
All AES channels (8) are available on an audio crossbar which permits selection of AES
channels for the digital and analog audio output stages. (Selected using the radio
buttons). Each selected AES stream can be individually muted using the checkboxes
provided.
Although not graphically shown, all AES channels (8) are fed through a fixed 1 Frame
delay and embedded back into the down converted digital outputs.
Page 19 of 29
