10
|
Care & use/installation
GriLL won’T LiGhT
first, confirm that the grill is getting electricity by turning
on the lights, then
:
Check the igniters
your lynx grill uses an electric ignition system that does
not spark. instead, the igniters will glow constantly when a
control knob is turned on.
• ensure that all burner controls are set to off.
• lift open the cooking surface.
• turn the burner knob on and wait approximately
1 minute for the igniter to glow.
• Check all igniters. if they do not glow, proceed with
trouble shooting.
trOuBleSHOOtinG YOur lYnx Grill
POtentiAl PrOBleMS
before you call for service
Please check a few things before calling for service:
•
Is there fuel supplied to the grill?
•
Is the main shut-off valve open?
•
Are you using the correct type of fuel? (LP or Natural Gas)
(See INDEX: “Gas Requirements” for further details.)
•
Is your propane cylinder empty? Have you recently refilled
the propane cylinder? If so, is the connection tight?
•
Have you opened the valve on the propane cylinder?
•
Is the grill plugged in to a live electric circuit?
If you’ve checked the above items, review the trouble-
shooting list below before calling Lynx for service.
proper plaCement of eaCh Burner is
CritiCal. after Cleaning they must Be
Centered on the Brass orifiCe,
resting leVel Without any roCKing.
failure to meet these Conditions may
Cause a Very dangerous Condition that
Can Cause personal inJury and prop-
erty damage.
WarnIng
SmeLL oF GAS whiLe CookinG
if you smell gas While the grill is operating, im-
mediately turn off all Burners and shut off the
main fuel supply.
• perform a leak test (see indeX: “leak test” for further
details.)
•
Check for blockages
(see indeX: “Clean the Burner”
for further details.)
LiGhTS won’T LiGhT
Check the Burners
if the igniters are working check to see if gas is reaching the
burners by attempting to match light a burner.
Be Careful! if the Burner fails to ignite, Wait
5 minutes Before attempting to ignite other
Burners! (see indeX: “match lighting” for further details.)
if match lighting doesn’t work, re-check fuel connections
for leaks and ensure the supply is of the correct type and is
of adequate pressure. (see indeX: “leak test” for further
details.)
if the burner will light with a match, then the igniter may not
be functioning correctly. Call for service.
if the burner will not match light, and you know you are
getting gas, wait for any gas to dissipate and remove the
burner and check it for blockages.
