lynx System Developers MYLAPS, Quick Start Manual

Page: 1 / 2

www.facebook.com/finishlynx www.finishlynx.com
L
YNX
S
YSTEM
D
EVELOPERS
, I
NC
.
MYLAPS BibTag Decoder
FinishLynx LapTime Integration QSG
Quick Start Guide (v1.00)
Introduction
The following guide will walk you through the configuration of your
MYLAPS BibTag decoder
, to allow the
integration of laptime data into
FinishLynx
. If at any point you need additional help, please contact Technical
Support: support@finishlynx.com.
REQUIREMENTS
1. MYLAPS BibTag Decoder.
2. Ethernet cable (not included) connected to the Timing & Scoring/FinishLynx PC.
a. Alternative (advanced) - cloud (CCNet) connection:
i. MYLAPS CCNet account
– send email request to
info.americas@mylaps.com
ii. SIM card with data plan
– for example, from
hologram.io
Basic Configuration
1. Connect the BibTag decoder to AC power.
2. Turn on the BibTag decoder (press the red power button) .
3. Use the Select and Scroll buttons to navigate the menus.
4. Navigate to Communication > Network and set:
a. Automatic = OFF
b. IP Address = 192.168.0.151 (IP of decoder must be on the same subnet as FinishLynx PC)
5. Navigate to General > Clock and set:
a. Time Zone = your time zone
b. Daylight Savings = ON/OFF
6. Connect the BibTag decoder to your EasyMat or SideAntennas.
7. Connect the BibTag decoder to the FinishLynx network switch. The BibTag decoder is now ready to be added
in Timing & Scoring.
Alternative (Advanced) Configuration
1. Install the SIM card in the MYLAPS GPS Modem
– follow the instructions in the
BibTag Timing System Manual
2. Turn on the BibTag decoder (press the red power button) .
3. Use the Select and Scroll buttons to navigate the menus.
4. Navigate to Communication > Server Communication and select GMS.