1
VC672
2.4GHz SMART SAFE CAM
①
Floodlight
②
Lampshade
③
Microphone
④
Camera
⑤
PIR (Motion Sensor)
⑥
Speaker
⑦
Pair/Power Button Cover
⑧
Pair/Power (
PAIR/
) Button
PACKAGE CONTENT
The Smart Safe Cam is packed specially to minimize
the chance of the contents being damaged during
shipping and handling. Please check the unit carefully
and confirm the contents listed below are included.
No. Item
Qty
1 Base
Unit
1
2 Screw
Pack
1
3 Halogen
Bulb
1
4
Operating Instruction Manual
1
INTRODUCTION
Your SMART SAFE CAM is a unique surveillance
system for your home or business. At night, the
built-in passive infrared (PIR) motion sensor turns on
the light when it detects motion in its coverage area, so
that camera images can be clearly seen. During the
day, the built-in photocell sensor saves electricity by
deactivating the light. This camera can link up with a
control panel (after code learning) and save the
recorded image on the panel. Pre-recording function
allows you to trace event happening, and function
settings can be done via the control panel.
The unit is designed for both indoor and outdoor
usages.
Note:
Read this entire manual before you start to install
the system.
BEFORE START
BULB INSTALLATION
CAUTION
: Always handle quartz halogen bulb with a
soft cloth. Do not touch the bulb with your bare hand
as it will shorten the bulb life.
(1) Do not touch the light while it is in use or still hot.
Allow it to cool off (about 5 minutes) before
touching it.
(2) Do not use halogen bulb rated higher than 150/120
watts.
(3) Disconnect the power cord or wall switch and then
use a cross head screwdriver, loose the screw at
the bottom edge of the front surround (FIGURE 1).
FIGURE 1
(4) Take off the front surround. Install bulb by inserting
one end first and depressing until enough
clearance is gained to seat the other end of the
socket. Rotate halogen bulb to assure proper
seating. Refit the front surround in place and
fasten the screw (FIGURE 2).
FIGURE 2
Side View &
Interior View
Front View
Bottom View
