27
Introduction to RoomPerfect
™
It is very difficult to design a perfect listening environment with a symmetrical setup and a perfect
reverberation time without vibrating surfaces like windows. A traditional setup of speakers requires uneven
distances to back and side walls to avoid having the reflections arrive to the listening position at the same
time, as this would have a negative effect to the frequency response. Having strong reflections after each
other is though causing smearing of the sound and reduces the overall dynamic performance.
RoomPerfect™ is designed to analyze and correct for the negative effects that the listening room has on the
speaker sound. Correcting the frequency response only, the setup of speakers should focus on having the
optimal dynamic performance by positioning all speakers as close to the back wall as possible
– and the
sub(s)preferably into the front corners of the room
Other correction systems will at their best offer a range of target curves for the calibration, whereas
RoomPerfect™ will identify the sound properties of your speakers and use these for the calibration.
RoomPerfect™ is therefore not just an equalizer, but in fact the only true room correction system.
If you want to change the target curve (the tonal balance of your speakers) for the
calibration, you can enter your own pre-eq filter design under the Output Setup. Through
a new calibration process,
RoomPerfect™ will then clean up the new tonal balance.
Global filter
The global filter improves sound quality across the whole room. When you are moving around a room, the
global filter gives the best result.
Focus position
The focus filter improves the sound quality at a specific listening position. This makes the focus filter the best
solution for optimal sound quality at a single listening position. A total of 8 focus positions can be stored after
the initial calibration.
for more detailed information.
