23
Enabling this will start the Guided Speaker Setup for the 2nd speaker setup. When complete, the menu item
Speaker Setup will be available in the main menu, allowing you to easily switch between the two setups.
WARNINGS:
Never run the TDAI-3400 in Bridge Mode with another amplifier!
Never connect speaker cables to High Level Inputs of a subwoofer!
Enable limiter
Normally increasing the volume setting of any amplifier above the nominal specification will allow for higher
levels
– just with higher distortion levels. Enabling the limiter will ensure that no matter the overall volume
setting, the output stage of the TDAI-3400 will never exceed specified distortion levels.
Routing
The available settings are:
•
Full range allows the signal to pass unfiltered.
•
Crossover will open for other menus for specifying the signal routing
Level
Reduce the signal level for this output with up to 24 dB to match the levels of other output channels.
Eq
Select any of the built-in equalizer filters or select
“Custom” for designing your own filter to optimize the
sound from your speakers. See the chapter Voicings, for input as to the design of filters.
Filter
Sets the type of crossover filter to be applied to this output
•
High pass: Removes the frequencies below the crossover frequency.
•
Low pass: Removes the frequencies above the crossover frequency.
Filter Type
Sets the type of crossover to be applied to this output
•
LR (Linkwitz Riley): 2nd, 4th or 8th order.
•
BW (Butterworth): 1st, 2nd or 4th order.
