LXNAV S10 Series, User Manual

Page: 66 / 121

Rev #37
Version 8.0 April 2021
Page 66 of 121
5.7.9.3.4 FLARM Urgent Alarm:
For very close FLARM targets the S8x/S10x gives a short or long message, just a beep or be
turned off (6-8 seconds before possible collision).
The volume for Vario, FLARM and Speech can also be adjusted directly via the
upper rotary knob whilst in the FLARM, Waypoint and Task Modes.
For the alarm sound the user has the possibility to select between beep, short message and
long message sounds.
Short message is of the form: “Traffic two o’clock”
Long message sounds like: “Traffic two o’clock, two kilometres, two hundred meters above”.
5.7.10 Obs. Zones
The default Observation Zones can be configured in this section for all tasks.
The Start, Waypoint and Finish zone can be configured separately although the setup is very
similar.
•
Direction: Options include Start, Previous, Next, Symmetrical or Fixed angle.
•
Angle 12 : is greyed out unless fixed angle is specified in Direction.
•
Line Check Box ; typically used for Start and Finish. If line is checked then Angle 1,
Angle 2 and Radius 2 are greyed out.
•
Angle 1 : Sets the angle of the Turn Point Zone.
•
Radius 1 : Sets the radius of the Turn Point Zone.
•
Angle 2 : Sets angle 2 for complex Turn Points and Assigned Area Tasks.
•
Radius 2 : Sets the radius for complex Turn Points and Assigned Area Tasks.
•
Auto Next : Typically used in racing tasks, this will change the navigation of the
S8x/S10x to the next turn point when a single fix is made within the Turn Point Zone.