E-EQ-VX4OGWW-H-ARC
VX4 User’s Guide
Installation
Install Mounting Brackets
Caution:
This device is intended to transmit RF energy. For protection against RF exposure
to humans and in accordance with FCC rules and Industry Canada rules, this
transmitter should be installed such that a minimum separation distance of at least
20 cm (7.8 in.) is maintained between the antenna and the general population.
This device is not to be co-located with other transmitters.
Equipment Needed:
Phillips No. 1 screwdriver and a Torque wrench capable of measuring to 50
inch pounds (5.64±.56 N/m).
Note:
Torquing tool is not supplied by LXE. Bolts, washers, and wrench needed when attaching
the bottom mounting bracket to the vehicle are not supplied by LXE.
Before installation begins, verify you have the following vehicle mounting bracket assembly
components:
Components
Back Mounting Bracket Assembly
This bracket is attached to the VX4. It is pre-
assembled at LXE.
6 each 8-32 x 7/16 Pan Head Screw (connects
the bracket to the back of the computer)
4 each 8-32 x 3/8 Flat Screw (connects the
bracket with isolators to the bracket
mounted to the back of the computer)
Bottom Mounting Bracket
This bracket is mounted to the vehicle. Then it is
connected to the Back Mounting Bracket and VX4
assembly.
6 each 1/4 Flat Washer
6 each 1/4 Lock Washer
6 each ¼-20 Bolt
