LXE MX5X, Reference Manual

Page: 192 / 296

Summit Client Configuration 175
E-EQ-MX5CERG-D MX5X Reference Guide
Enter the Password, if desired. Tap OK.
Tap the Commit button to save the new profile configuration. Perform a warm reset to connect
using the new profile configuration.
See Also: WPA/LEAP Authentication later in this section to configure the client for WPA LEAP.
See Also: Sign-On vs. Stored Credentials earlier in this chapter if the username and password are
left blank during setup.
EAP-FAST Authentication
Start the Summit Utility by tapping the Summit Client icon.
Tap the Admin Login button on the Main panel. Enter the Admin password and tap OK.
Tap the Config or Profile tab.
or
Figure 5-15 Configure a Summit Profile for EAP-FAST
Enter the SSID of the Access Point assigned to this profile.
Set Auth Type to Open.
Set EAP Type to EAP-FAST.
Set Encryption to WPA TKIP.
To use Stored Credentials, tap the Credentials button.
No entries are necessary for Sign-On Credentials as the user will be prompted for the User name
and Password when connecting to the network.
The SCU supports EAP-FAST with automatic or manual PAC provisioning. With automatic PAC
provisioning, the user credentials, whether entered on the saved credentials screen or the sign on
screen, are sent to the RADIUS server. The RADIUS server must have auto provisioning enabled
to send the PAC provisioning credentials to the client device. Please refer to the
LXE Security
Primer for more information on the RADIUS server configuration.
To use Stored Credentials, tap the Credentials button.
Note: No entries are necessary for Sign-On Credentials as the user will be prompted for the
User name and Password when connecting to the network.