LXE MX5X, Reference Manual

Page: 187 / 296

170 Summit Client Configuration
MX5X Reference Guide E-EQ-MX5CERG-D
5. The default is to use the entire certificate store for the CA certificate. Alternatively, use the
Browse button next to the CA Cert (CA Certificate Filename) on the Credentials screen to
select an individual certificate.
6. For EAP-TLS, also enter the User Cert (User Certificate filename) on the credentials screen
by using the Browse button.
7. Click the OK button then the Commit button.
8. When the device attempts to connect to the network, a sign-on screen is displayed.
9. Enter the Username and Password . Click the OK button.
Figure 5-9 Sign-On Screen
Verify the device is authenticated by reviewing the Status tab. When the device is property
configured, the Status tab indicates the device is Authenticated and the method used.
The sign-on screen is displayed after a reboot for each of the listed protocols.
Note: Complete details are provided in the appropriate Summit Wireless Security section
following in this chapter.
If a user enters invalid credentials and clicks OK , the device associates but does not
authenticate. The user is again prompted to enter credentials.
If the user clicks the Cancel button, the device does not associate. The user is not
prompted again for credentials until the device is rebooted, the radio is disabled then
enabled, the
Reconnect button on the Diags tag is clicked or the profile is modified and
the Commit button is clicked.