LXE MX1-IS, Reference Manual

Page: 46 / 164

36 Installed Software
MX1 I-Safe Reference Guide E-EQ-MX1ISRG-F
\AGENT
The SNMP agent files are loaded on mobile devices with a 2.4GHz radio only.
Please refer to the “SNMP Agent Reference Guide” and “Client Configuration
Manager Reference Guide” for more details on the SNMP agent. See section
“Avalanche” for devices using Wavelink Avalanche.
AGENT.EXE
Diagnostic agent. Provides limited access to the LXE Private MIB.
CFGAGENT.EXE Configuration agent. Provides full access to the LXE Private MIB.
REV.BAT Displays current revision identifier.
\DOS Files
ANSI.SYS Interprets ANSI escape sequences.
ATTRIB.COM Displays or modifies the attributes associated with a file.
CHKDSK.EXE Checks the status of a disk and displays a report. Can also fix disk
errors.
COMMAND.COM A DOS file that runs programs, manages files, controls information
processing, directs input and output, among other functions.
DELTREE.EXE Deletes one or more directory trees or individual files.
EMM386 Memory manager.
FORMAT.COM Formats a read-write disk drive (flash and RAM drives only) removing
all data.
HIMEM.SYS Extended memory manager.
MEM.EXE Displays the amount of used and free memory on a computer.
MODE.COM Configures system devices.
MORE.COM Displays 25 lines of output at a time.
NED.CFG Configuration file for NED.EXE ASCII text editor.
NED.EXE This program is used when editing ASCII text files.
PRINT.COM Prints a list of files, up to ten files.
REMDISK.EXE NOT USED. Companion file to REMSERV.EXE. Each computer must
use the same baud rate and packet or non-packet-style transmission.
This file runs on one computer and REMSERV.EXE runs on the other.
REMSERV.EXE NOT USED. Companion file to REMDISK.EXE. This file runs on one
computer and REMDISK.EXE runs on the other. Used for manipulating
files on two computers’ hard disks. Use a null modem cable connecting
both serial ports.
REV.BAT Displays the version number of ROM-DOS in use.
ROM-DOS Operating system.
SYS.COM NOT USED. Adds system files to disks.
VER Displays the current version identity of DOS. This command is run at
the DOS prompt.
XCOPY.EXE NOT USED. Copies multiple files and, optionally, subdirectories from
one disk to another.
Note: Files that are loaded on the MX1-IS and NOT USED may be deleted at a later date to
increase available disk space.