MX1-IS Components
7
E-EQ-MX1ISRG-F
MX1 I-Safe Reference Guide
Power On and Off
Turn On the MX1-IS
Press the Power button until the display turns on. The power button is located at the bottom of the
keypad.
Figure 1-5 Location of the Power Button
Note:
The IR window and four battery charger connectors are present, but they are non-
powered and non-functional.
When the MX1-IS is powered on, the display will begin scrolling power-on information as
software and drivers are loaded. When the display has stopped scrolling and a DOS C: prompt is
displayed or an application begins, the power on sequence is complete.
Turn Off the MX1-IS
Press and hold the Power button down. The unit will emit three short beeps and one long beep.
After the long beep the MX1-IS will power down. The Power button and the display will turn off.
The Power key function is configured in the BIOS Setup.
Note:
Quickly tapping the Power button will place the MX1-IS operating system in Suspend
mode.
Troubleshooting
If the MX1-IS will not turn off , force a Power Off by holding the Power key down for 15 seconds
and the MX1-IS will power off. Locate and correct the problem before powering the MX1-IS
back on – e.g. very low battery power, radio conflict, unexpected software application result, etc.
Summary of Contents for MX1-IS
