LV switch IPPBX3000, User Manual

Page: 25 / 195

LvSwitch IPPBX 3000 Manual
23
2.7.2 The steps to install power cable
Before installing the equipment, it is necessary to confirm whether the ground point of the building's
power supply system is buried, and then install the equipment after confirming the burial. It is recommended
to use a single-phase three-wire power socket with a ground connector, and the ground should be reliably
grounded.
Confirm the AC power input range: 100V-240V AC;50HZ-60HZ.
1. Make sure the ground cable has been installed right.
2. Cut off the AC supply power ,keep the power switch being off.
3. Plug the power cable onto the power socket.
4. Plug the other end of power cable on the socket on the device.
5. Turn on the power switch on the device.
6. Check whether the power indicator on the front panel is on or not,if it is on that states the power connection is
right.
Attention:
Please keep the power plug horizontal to the power socket.
2.8 Connect the signal cable
2.8.1 Connect Ethernet port
Ethernet electrical interface generally adopts 5 types of twisted pair wires to connect Ethernet, as shown in
the figure below:
Figure 2-2 Ethernet cable
Depending on the usage, Ethernet cables can be divided into standard network cables (i.e., straight-through
network cables) and cross-over network cables. There are 8 wires in the cables, which are divided into 4 pairs.
Each pair is a pair of twisted-pair cables, sorted as follows:
568A/568B sort rule:
568A
White
green
green
White
orange
Blue
White
blue
Orange
White
brown
Brown
568B White Orange White Blue White Green White Brown