Product Name:
Resin/Metal Swan Outdoor Fountain
SKU #:
WHF1313
Contact: [email protected]
Instruction Manual
Please save this manual for future reference.
Thank you for purchasing this Luxen Home product. This product has been manufactured with the highest
standards of safety and quality.
PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
Unpack all parts from Styrofoam and bubble wrap inside the carton to ensure there are no missing or damaged
parts. If any parts are missing or damaged, do not attempt to assemble or use the product.
CARTON CONTENTS:
Description
Quantity
Fountain Top
1
Swan
1
Pump
1
Compatible Pumps for this fountain:
Pump Model No.
JR350/LED
JB350/LED
YH400/LED
YH-LV90T
Tools required for assembly:
No tools required for assembly.
Assembly Instructions:
1.
Unpack the contents of the box and check to make sure that all items are accounted for and in good
condition.
2.
Select a flat, level surface for the assembly and final location of your fountain.
3.
The water supply tube is located at the base of the fountain top. Place the pump inside the swan, and
connect the water supply tube to the pump outlet. Draw the pump cord out from the swan (opening at the
top). Place the fountain top securely on the swan.
4.
Add clean water to the fountain. The water level should be approximately 30mm lower than the edge of the
basin.
5.
Connect the power cable to outlet. If installed properly, water flow in the fountain will begin shortly.
6.
Please do not use the electrical plug in wet weather conditions. Please note: On first use, there may be air in
the pump. It may take several minutes until all the air escapes.
7.
To eliminate the possibility of water damage around your fountain, check for leaks and excessive splashing
after the initial setup of your fountain. It is highly recommended that this fountain be placed in an area
where it cannot be damaged.
8.
Do not leave your fountain running for extended periods of time when no one is present to observe the
