LuxaFlex PowerView Pebble Remote, Reference Manual, Page: 41 / 43

[ 80 ] [ 81 ]
Scenario 4
ISSUE
The batteries in my showroom Pebble® Remote(s) don’t last long.
Cause Solution
The remote is not
frequently used but it
is placed or located in a
location where it is subject
to frequent movement
(e.g., a frequently accessed
drawer).
1 . Preserve battery life by keeping the remote in a location where it will not be
moved inadvertently . This will prevent the auto-wake feature from turning the
backlights on and draining the batteries .
The remote is handled
frequently, daily.
1 . Preserve battery life by disabling the auto-wake function by
PRESSING
and
HOLDING
the
Group 6
button on the remote for approximately six seconds . The
Group numbers (1-6) will blink once to indicate the auto-wake function has been
disabled .
*To turn the auto-wake function back on:
1 .
PRESS
and
HOLD
the
Group 6
button for approximately six seconds . The Group
numbers (1-6) blink twice to indicate the accelerometer has been turned back on .
The batteries are not dead,
but remote is in “Learning
Mode”.
In Learning Mode, only the Group buttons blink when the Open or Close button is
pressed .
1 . To get out of Learning Mode,
PAIR remote to another remote or Hub or PRESS the
Reset button on the remote (behind the battery cover .)
Scenario 5
ISSUE
PowerView® window treatment does not correctly respond to Scenes in the App. Or, a PowerView®
window treatment responds to Scenes to which it does not belong in the App.
Cause Solution
A manual 12-second reset
was performed at the
headrail; or, the window
treatment was previously
deleted from the App and
then re-Discovered. Room
and Scene settings, however,
did not purge. Instead, this
information continued to be
retained in the headrail.
1 .
OPEN
the specific Shade Information page for the window treatment(s) in
question .
2 .
SELECT
the “
Advanced
” option .
3 .
SELECT “Clear Shade Memory”
. This command will remove the window
treatment from the Room(s) and/or Scene(s) to which it is associated .
NOTE:
If all the window treatments in a Scene are cleared using the “Clear
Shade Memory” command before each is placed back in a Scene, then the
Scene will automatically be removed from the App and will need to be
recreated .
4 .
RE-ASSIGN
the window treatment to a Room(s) and Scene(s), as desired . Also,
re-set its Scene position, as desired .