Lux Tools A-KS-2x20/4/30, Original Instructions Manual

Page: 58 / 244

GB
58
– Lay device securely with the tank
cover (2) upwards.
– Before opening, clean the tank cover and
the filler neck if necessary.
– Open flap and remove tank cover.
– Carefully fill up the saw chain oil. Do not
spill!
– Read the oil level at the inspection
glass (9). The oil stand must be placed
between
[MIN]
and
[MAX]
.
– Attach tank cover and close flap.
– If you have spilled any saw chain oil, be
sure to wipe it up.
Operation
Safety equipment
The device has several pieces of safety
equipment which reduce the risk of injury
when working:
Claw stop
The claw stop enables the motor block to be
secured to the wood when using pull saws.
Uncontrolled kickback of the saw is thus
made more difficult. The process also exerts
pressure on the saw chain thanks to the gen-
erated leverage.
Chain catcher
The chain catcher serves to catch a torn saw
chain or one which has jumped out of the
guide. Through regular maintenance of the
saw rail and correct and regular tensioning of
the saw chain, accidents of this type can be
prevented.
Rear hand guard
The rear hand guard serves to protect the
hand against a jumped chain and disturbing
branches and twigs.
Charging the battery pack
The battery pack must be charged prior to the
first start-up (charging time:
►
Technical
data – p. 63
).
– Press in the locking button (17) and
remove the battery from the device.
– Insert the battery pack into the charger.
– Plug the charger into the power supply.
The charging status is displayed by the con-
trol lights (18).
– Slot the battery pack into the device and
make sure it clicks into place correctly.
Checking the remaining capacity of the
battery
– Press the button (16).
NOTICE! Environmental damage!
Since the saw chain oil can penetrate
the environment during operation,
biologically-degradable special vege-
table-based saw chain oils should be
used.
WARNING! Risk of injury! Comply
with all safety instructions when han-
dling rechargeable devices.
NOTICE! Risk of damage to the
unit!
Due to the high operating cur-
rent, the unit must only be operated
with batteries with a capacity of at
least 4 Ah (article number 196052).
Replacement batteries with article
number 196051 are not suitable for
operation with this unit.
NOTICE! Risk of damage to the
unit!
Do not allow the battery pack to
deep discharge.
Note: If the battery is fully loaded, the
charger automatically switches over
to the maintenance charge function.
The battery can thus remain in the
charger permanently.