LION I/O Modules
▪
Installation
34
6.8.3
Wiring
6.9
Connecting the Modules
Technical Data – L-Bus
2
Interface
1. Connect the modules with the sing-
le conductors of the cable.
2. Remove the jacket of the cable,
where the shield clip will be, until
the cable shield can be seen.
3. Fix the cable with the shield clip,
the cable shield must have contact
to the shield clip.
The shield clip can be adjusted in 3
levels, depending on the cable si-
ze.
4. For strain relieve fix the cable with
a wire strap (2) to the module as
shown in the drawing.
5. Insulate the cable.
Fig. 30: Wiring EMC Shield Clip Set
Electric currents can cause injuries and can damages the whole system.
▪ Switch off the power of the system when connecting or disconnecting the
modules.
▪ Hot plugging is not supported by the system.
In the LION system, the modules are
connected to each other via internal
BUS system L-Bus
2
. The BUS is a
special fieldbus, invented by LÜTZE.
For connecting the modules, follow
the description below.
Fig. 31: LION System – Module Connection
Plugging cycles
500
Contacts
14
Protection
against incorrect insertion
