Chapter 3: Intended Use
___________________________________________________________________________________________
9 | Installation, Operation & Maintenance Instructions EASYCHLORGEN
3. Intended Use
3.1 Notes on product warranty
Any non-designated use of the device can impair its function
and the protection provided. This leads to invalidation of any
warranty claims! Please note that liability is on the side of
the user in the following cases:
•
The device is operated in a manner which is not consistent
with these operating instructions, particularly safety
instructions, handling instructions and the section "Intended
Use".
•
Information on usage and environment (see section 5
“Technical data“) is not adhered to.
•
If people operate the device who are not adequately
qualified to carry out their respective activities.
•
No original spare parts or accessories of Lutz-Jesco are
used.
•
Unauthorised changes are made to the device.
•
The user uses different salt quality than that indicated in this
instruction manual.
•
Maintenance and inspection intervals are not adhered to as
required or not adhered to at all.
•
The device is commissioned before it or the corresponding
system has been correctly and completely installed.
•
Safety equipment has been bridged, removed or made
inoperative in any other way.
3.2 Intended purpose
The EASYCHLORGEN on-site electrolytic chlorination system is
intended for the following purpose: Generation of a <1% sodium
hypochlorite solution using salt, water and electrical energy, with
the resulting media to be used as a disinfection agent for the
chlorination of drinking water, swimming pool and industrial
waters.
The concentration of the sodium hypochlorite solution produced
is 0.6% (+/-0.1%) Cl
2
by weight.
3.3 Device Revision
This operating instruction manual applies to the following
devices:
Device
Month /year of
manufacture
EASYCHLORGEN 4250/8500
10/2017 onwards
3.4 Sodium chloride chemical specification
The EASYCHLORGEN system is designed to be used with dry
crystalline/granular salt. Salt can be purchased in bulk/ pallet
quantities to obtain best economy. When ordering salt from your
supplier always specify the brand or specific quality you require,
so that, in the unlikely event of any shortage of stock, you will still
receive an equivalent grade of salt. The use of pure vacuum
dried (PVD) salt, or compressed PVD salt chips is not
recommended.
Note:
Within the European Union the supply of salt for use as a
precursor for in-situ generated active chlorine falls under the
Biocidal Products Regulation (BPR). Please consult your salt
supplier to check for compliance with this regulation!
Property
Unit
Specification
Arsenic (As)
mg/kg
<13
Cadmium (Cd)
mg/kg
<1.3
Chromium (Cr)
mg/kg
<13
Iron (Fe)
mg/kg
<10
Mercury (Hg)
mg/kg
<0.26
Nickel(Ni)
mg/kg
<13
Manganese (Mn)
mg/kg
<0,5
Lead (Pb)
mg/kg
<13
Antimony (Sb)
mg/kg
<2.6
Selenium (Se)
mg/kg
<2.6
Bromide
% of NaCl
<0.01
Calcium
% of NaCl
<0.01
Magnesium
% of NaCl
<0.01
Note
Damage to the system due to incorrect salt.
Using the incorrect grade of salt may cause damage to the
electrolyser cell and invalidate your warranty!
Please check with your supplier that the salt product supplied
meets the minimum specification above.
3.5 Water Quality
Drinking water or water of a similar quality should be used. It
should be free of solids and suspended matter.
The temperature
of the water entering the system
must be in the range of 5-20
°
C.
3.6 Standard warranty conditions
Equipment
Warranty Period
Electronic devices
2 years
Electrolyser
5 years limited, pro-rata
Wearable items
12 months
