Lutron Electronics Co., Inc. 7200 Suter Road
Coopersburg, PA 18036-1299 USA
Customer Assistance | 1.800.523.9466
USA, Canada, and the Caribbean
| +1.610.282.3800
Others
| www.lutron.com
Part of the Vive System
Vive Integral Fixture Control
Digital Link Interface Installation
Start Here
English
Important Notes:
• For installation by the luminaire manufacturer.
• Use copper conductors only.
• Check to see that the device type and rating is suitable for the application.
•
DO NOT
install if product has any visible damage.
• If moisture or condensation is evident, allow the product to dry completely
before installation.
• Operate between 32 °F to 140 °F (0 °C to 60 °C), ambient.
• 0% to 90% humidity, non-condensing.
• For indoor use only.
DFC-OEM-DBI
Lutron Digital Link Interface
Supplies power to the following devices:
DFCSJ-OEM-OCC
DFCSJ-OEM-RF
when used in conjunction with Lutron EcoSystem LED drivers.
Install the Digital Link Interface
Intended to be installed within the interior of a luminaire (not for external/remote mounting).
A
Mount the Digital Link Interface to the interior of the fixture surface using two screws.
B
Connect to line and sensor/driver as shown in diagram below.
WARNING! Shock Hazard.
May result in serious injury or death.
Turn off power at circuit breaker before installing the unit.
For more information, see
http://www.lutron.com/TechnicalDocumentLibrary/3691039.pdf
Notes:
For more information on Lutron wireless fixture controls, see P/N 3691039 on www.lutron.com
For DFCSJ-OEM-OCC or DFCSJ-OEM-RF installation instructions visit www.lutron.com
Please read before installing
1
Input: 120-277 V
~
50/60 Hz 1 A
Output: 18 V
-
60 mA
041661
Rev. B
07/2018
Dimensions
Measurements shown as: inches (mm)
1.17
(29.7)
Dia. 0.21 (5.3)
0.81
(20.5)
5.06
(128.5)
4.60
(116.9)
Dashed line = Fixture
Vive Integral Fixture Control
Line
Neutral
EcoSystem Driver (up to 4)
Fixture Control Digital Link Interface
Test
Link
Pico Remote Control
(up to 10)
Vive Wireless Hub
(1 maximum)
Radio Powr Savr
daylight sensor
(1 maximum)
Radio Powr Savr
occupancy sensor
(up to 10)
E1 (Violet)
S- (Blue)
E2 (Violet)
S+ (Blue)
EcoSystem
polarity-free
digital link
EcoSystem
polarity-free
digital link
FCC / IC Information
This device complies with part 15 of the FCC Rules and Industry Canada license-
exempt RSS standard(s). Operation is subject to the following two conditions:
(1) This device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation. Modifications
not expressly approved by Lutron Electronics Co., Inc. could void the user’s authority
to operate this equipment.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Re-orient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Limited Warranty
:
http://www.lutron.com/TechnicalDocumentLibrary/3601321.pdf
Required Components
For each fixture, you will need:
(DFC-OEM-DBI)
Vive Integral Fixture Control with Sensor
(DFCSJ-OEM-OCC)
Vive Integral Fixture Control (RF only)
(DFCSJ-OEM-RF)
Note: Daylighting functionality is not available
in the DFCSJ-OEM-RF
LED lens
LED/Daylight sensor lens
PIR lens
Button
Button
+
One Digital Link Interface
At least one EcoSystem driver
One Vive Integral Fixture Control
OR
+
Lutron, Pico, Vice, and EcoSystem are trademarks of Lutron Electronics Co., Inc., registered in the U.S. and other countries. Radio Powr Savr is a trademark of Lutron Electronics Co., Inc. NEC is a registered trademark of the National Fire Protection Association, Quincy, Massachusetts.
©2014 – 2018 Lutron Electronics Co., Inc.
NOTE: Wireless sensors and controls must be located within 60 ft
(18 m) line of sight, or 30 ft (9 m) through walls of each other.
30 ft (9 m)
Maximum
Pico Remote
Control
Fixture Control
Vive Integral Fixture Control
