5
Lutron Athena System User Guide
Operations and Maintenance
Introduction
This manual includes the following information:
• Service contact list
• General safety instructions associated with the system and its components
• System overview
• Routine preventative maintenance requirements
• Warranty information
Specific descriptions of how the various system components were integrated into your specific location and
how the overall system operates to control your building needs can be obtained by contacting our Technical
Support department at 1.844.LUTRON1.
Thank you again for your purchase, and we hope that you enjoy your new Lutron system.
Service Contact List
For factory service or to order replacement parts, contact your Lutron office or using the contact information
listed below:
World Headquarters
Lutron Electronics Co., Inc.
7200 Suter Road
Coopersburg, PA 18036-1299
U.S.A.
Toll-free: 1.844.LUTRON1 TEL: +1.610.282.3800 FAX: +1.610.282.1243 [email protected]
Safety Precautions
Safety information and / or precautions are included with each product and can also be found at www.lutron.com.
Please refer to these manuals for safety related information and instructions associated with each of the system’s
components / devices.
Under no circumstances should Lutron supplied safety information and instructions supersede, or be
considered a substitute for, your local organization’s electrical safety procedures.
General Safety Precautions:
• Only personnel with the proper electrical safety training qualifications should be permitted to perform
maintenance on Lutron control equipment.
• Only personnel with sufficient training on, and knowledge of, Lutron controls equipment should be
permitted to perform maintenance on this equipment.
• Always de-energize, lockout, tagout, and verify de-energized, all electrical equipment prior to performing work
on that equipment. Perform these activities only in accordance with your local site’s safety procedures.
• Multiple circuits may feed some Lutron equipment. Locate and lock each supply breaker in the OFF
position before performing maintenance work. Prior to performing maintenance on de-energized Lutron
equipment, always test for the presence of voltage before beginning the maintenance work, even if you
are certain that you have completely de-energized the equipment.
• If something unexpected occurs while performing maintenance work on Lutron equipment, stop work
immediately, secure the work site, and seek help.
• Use only Lutron-approved replacement parts for easy mounting, installation, and relocation.
