Lupus Electronics LUPUSEC-XT2, Manual

Page: 98 / 148

98
ENGLISH
PIR motion detector
Product description:
1.
Test button with LED indicator
2.
Tamper contact
3.
Battery breaker (delivery status)
4.
Corner mount
5.
Status update on/off (jumper 2)
6.
Switch (jumper 3) to increase the sensitivity
LED indicator:
The LED is usually off in normal operation, except for the following situations:

If the battery runs low, the LED lights up for 2 seconds after motion detection.

If a tamper alarm is triggered, the LED lights up for 2 seconds while the alarm
signal is being transmitted.

Pressing the Test button for approx. 5 seconds will set the motion detector to the
test mode for 3 minutes. During this time, the LED lights up with every motion. Use
this function for optimal alignment.
Battery:

The motion detector requires a 3.0 V CR123 lithium battery. With 20 detected
motions per day, the average battery life is approx. 3 years.

If the battery runs low, the motion detector sends the status to the control unit.
Put the PIR motion detector into operation
1.
Remove the battery breaker from the back of the motion detector to supply the
device with power.
2.
The device starts. This process takes approx. 30 seconds. Wait until the LED
stops flashing and do not trigger the motion detector during this time.
3.
Start the configuration menu of the control unit and open the menu Sensors

Add. Click on Start.
4.
Press the Test button of the detector once. The menu should indicate the motion
detector after a short while.
5.
Start the Test mode of the control unit to verify that that the motion detector at the
intended location is within the range.
6.
Take the motion detector to the intended place of installation and press the Test
button of the device. The test menu of the control unit indicates the signal strength
of the radio transmission. The higher the value the better the radio signal (1-9).