![Lupus Electronics LUPUSEC-XT2 Manual Download Page 120](http://html1.mh-extra.com/html/lupus-electronics/lupusec-xt2/lupusec-xt2_manual_1950354120.webp)
120
ENGLISH
Panic button
Product description:
1.
Panic button
If this button is pressed for at least 3 seconds, the
control unit will trigger an alarm regardless of which
state the alarm system is in (Arm / Disarm / Home).
If this button is pressed for at least 8 seconds, the
panic alarm stops.
2.
TX LED indicator
Briefly lights up upon signal transmission.
Battery:
The panic button requires a 3 V 240 mAh lithium button cell. The average battery life
is approx. three years. The control unit will inform you in time about the battery
running low.
Put the Panic button into operation
1.
Unscrew the screw at the bottom and open the housing.
2.
Insert the battery with the flat side up.
3.
Close the housing.
4.
Open the configuration page of the control unit, open the menu “Sensors”
“Add”
and click on Start.
5.
Press the red panic (test) button.
6.
The configuration page of the control unit should list the panic button.
7.
Add the panic button.
8.
You can test the signal strength in the Range menu. For that purpose, go to the
intended place of installation, press Range test
Start in the control unit menu
Sensors
Range and then press the Test button of the panic button. The higher
the indicated number the better the reception (1-9).
Summary of Contents for LUPUSEC-XT2
