40
Settings menu
Comprises the sub-menus Contact ID, Control unit, Special codes, Text message
report, E-mail, Upload, and Automation.
Contact ID
To use the “Contact ID” menu, you must make use of a third party alarm center. The
alarm center will be connected via Contact ID to the LUPUSEC-XT1, informed about
any important status changes, and can react immediately.
The “Contact ID” menu provides altogether two boxes (URL1 + URL2), in which you
can enter the address of the alarm center/control center. The LUPUSEC-XT1 for this
uses the customary “Contact ID over IP” protocol.
If your control center does not support this or requires modifications, please contact
our support service.
Create the contact ID address to be used according to the following pattern:
rptn://ACCT@server:port
ACCT:
ID or customer ID, with which the alarm system is registered at the
alarm center.
Server:
The IP address of the alarm center server
Port:
The assigned port of the alarm center server
Example:
rptn://[email protected]:2280
Thus, each status change of the LUPUSEC-XT1 can be reported to the alarm center.
Automatic login notification:
Specify an interval for regular status reports to the alarm center. If such a
