121
Tag reader
Product description:
1.
Power LED (green)
2.
Status LED (red)
3.
Arm button
4.
Disarm button
5.
Batteries
6.
Function switches
7.
Tamper contact
8.
Tag (watertight)
LED indicators:
Both LEDs are off in the stand-by mode.
Power LED (green):
o
If a button is pressed, the Power LED lights up for 5 seconds to indicate the
operational readiness of the tag reader.
o
The Power LED flashes instead of being on constantly to indicate the battery
running low.
Status LED (red):
o
Flashes fast upon signal transmission.
o
Is permanently on in tag learn mode.
o
Flashes in installation mode.
Battery:
The tag reader requires three AAA 1.5 V alkaline batteries. The average battery
life with two activations per day is approx. four years.
The tag reader indicates the low battery status by the Power LED flashing. The
control unit is additionally informed about the battery status.
Power saving function:
As long as the tag reader is not used, it does not consume any electric power.
Only when a button is pressed is the tag reader activated for 5 seconds.
The tag reader goes off again automatically after 5 seconds.
Tamper protection:
The tag reader is protected against being opened in an unauthorized way or
being removed from the mounting surface.
If the tamper contact is triggered, the Power LED lights up and a warning signal
sounds. The control unit is informed about the tampering.
If the control unit is armed, the triggered tamper contact triggers an alarm.
In learn mode, the tamper contact is deactivated.
Function switches:
If the tag reader housing is open, you will see the function switch block with five
switches. These switches are all set to OFF by default.
