107
Wireless repeater
You can connect a maximum of 20 sensors to the LUPUSEC XT1. If the range of one
or more sensors is insufficient, you can increase this range with the wireless
repeater. You can almost double the transmission range with a repeater, because the
sensors are sending their signals first to the repeater and then the repeater relays
these signals to the control unit. The wireless repeater is not a sensor and therefore
not listed in the sensor list.
The repeater works on the 868.6625 MHz frequency and can amplify only sensors
within this frequency range. The repeater does not support the PIR network camera,
temperature sensors, wireless sockets, and in-wall relays.
S
TA
U
G
P
O
W
E
R
1.
Green LED: status indicator
On = Standby
Off = Off
Flashing = low battery
2.
Red LED: signal transmission
On = A signal is transmitted or received
Flashing = incorrect switch setting
3.
9 V DC 500 mA power supply connection
4.
Cover
5.
Mount
6.
Battery switch ON/OFF
7.
Buzzer
8.
Delete memory button
Note
:
We strongly recommend installing the repeater at a minimum distance of 20 meters
from the control unit to avoid signal interference.
1
2
3
6
8
7
4
5
