Luneau Technology Briot emotion2, Instruction Manual

Page: 74 / 162

Using your Edger...Special case
3-73 LTO
3.3.3.5 P
RODUCE A MANUAL BEVEL
3.3.3.5.1 S
ITUATION

You wish to visualise the lens thickness and adjust the finishing position.
3.3.3.5.2 P
ROCEDURE
To produce a manual bevel:
1. Load or create a job.
2. Enter its characteristics.
3. Proceed as shown on the flow chart.
3.3.3.5.3 I
MPORTANT NOTES

The maximum distance between the apex of the bevel and the front face is 5 mm.

If you wish to reposition the whole bevel, move the bevel apex in one direction to the required position. 
Then do the same from the opposite point.

To make a safety-bevel of any type, the minimum distance between the bevel apex and the front/rear face
must be greater than 1.6 mm. If it is less than 1.6 mm at any point of the lens, the safety-bevel will not be
produced at this point.
3.3.3.5.4 L
IMITS

If the maximum thickness of the lens is less than 2 mm, the applied bevel will automatically be of 50% type,
whichever type of bevel is selected initially.
3.3.3.5.5 R
ETOUCH

When the edging cycle is finished, remove the lens from the edging chamber without removing the block
so as to be able to retouch it if necessary.

Check the lens dimensions and finishing.