Luneau Technology Briot emotion2, Instruction Manual

Page: 51 / 162

Using your Edger...Usual procedure
3-50 LTO
3.2.7 B
LOCKING
/
CENTERING SYSTEM
3.2.7.1 M
AIN BLOCKING SCREEN
Follow the steps below to block a lens:
Enter the blocking/centering tab .
Note : The displayed values correspond to the selected decentering type.
Height
Pupillary
left
Half-pupillary
Pupillary left
Height
Pupillary
right
Half-pupillary
Pupillary right
Position of the pupil
(blue cross)
Display type
Vertical decen-
tering (delta or
boxing or mix)
Max. radius
of the lens
frame 
circumference
Min. diameter of the
lens to be ordered
#1 Select the side to be blocked by pressing directly on the frame 
concerned (right or left eye).
NOTE : The blocking screen replaces the main screen.A red and green letter at the
top of the screen (L or R) shows which side will be blocked.
#2 Place a lens holder, corresponding to the lens to be blocked.
NOTE : To block a lens which has to be regrooved, or a small lens (<45 mm) , it is
preferable to use the fitted lens holder (small diameter) (P/N S390017).
#4 Select the marking type (three points, progressive, etc.).
Result : A coloured target corresponding to the type of lens selected is displayed in the
main window.
#5 Centre the lens to be blocked so that the markings match the target.
#3 Place the lens to be blocked, after marking it, on its holder.
#6 Place a block fitted with an adhesive in the head of the blocker.
C
AUTION
! THE USE OF ADHESIVES WHICH ARE NOT SPECIFICALLY RECOMMENDED
BY BRIOT MAY RESULT IN MALFUNCTIONS DURING SUBSEQUENT EDGING

PHASES.
#7 Rotate the blocker head by 180°.
#8 Rotate the blocker arm.
#9 Lower the blocker head on the lens.
#10 When the blocking operation is complete, remove the blocked lens
from its holder.