Luneau Technology Briot emotion2, Instruction Manual

Page: 20 / 162

Precautions for use...Safety
2-19 LTO
2.1 SAFETY
2.1.1 O
PERATOR

Read the instructions carefully and always keep the manual near your machine so you can refer to it
easily.

This is a rotary machine: the wheels are potentially dangerous. Be very careful and keep your hands away
from the set of wheels.

Two people are necessary to move the machine.

When you activate the clamp shafts, keep your fingers outside the contact areas.

Before touching the fuses, disconnect the mains cable.

Make sure that the installation is perfectly water-tight.

Before servicing the edger, check that the mains cable is unplugged.
2.1.2 M
ACHINE

Make sure your voltage source corresponds to the voltage specified on the identification plate lo-
cated at the rear of the machine. If you are unsure of the type of current available in your premises, contact
your electricity company.

If the machine is not going to be used for a long period of time, disconnect the power cords from
the wall outlet.

The switch on the rear of the machine corresponds to the on/off function. Isolation from the grid is ensured
by the outlet cable plug.

Disconnect the machine if there is an electrical storm or when the machine is left unattended
for a long period.

Keep the machine away from any source of heat. A radiator is a heat source which can be detrimental
to the correct operation of the machine.

The openings in the cover are designed to ventilate the machine and contribute to its normal ope-
ration. Do not obstruct them or cover them.

Make sure that the machine is installed in a correctly ventilated room.

Do not overload the wall sockets or plugs because you would increase the risk of fire or electric shock.

Avoid using electric extension leads.

Keep the machine away from any source of dust.

Any servicing or work on the machine (with the cover open or closed) must be undertaken by a Briot tech-
nician.

If the machine is used in closed-circuit mode, do not add additives of any kind to the tank water. 


The symbol defines a general hazard, and you will find it:

on the controlled pump plug: risk of electrical shock,

on the edging chamber: risk of bodily hazard,

on the water inlet: risk if water inlet pressure is greater than 3 bar
LTO recommends installing a pressure reducer set to 3 bar upstream from the machine water inlet
circuit.
T
HE MANUFACTURER CANNOT BE HELD RESPONSIBLE FOR DAMAGE CAUSED BY ANY USE OF THE MACHINE
WHICH DOES NOT COMPLY WITH THE INSTRUCTIONS IN THIS MANUAL OR DISPLAYED ON THE MACHINE
ITSELF
.