DALI LED Driver 96 watt
-
Installation Instructions
Models PSDALI-96-24
Please read all instructions prior to installation and keep for future reference!
This LED Driver is to be installed in accordance with Article 450 of the National Electrical Code. The LED Driver must be
installed in a well ventilated area and free from explosive gases and vapors. Proper operation requires the free flow of air. As
this LED Driver is hardwired, it should only be installed by a qualified electrician. Suitable For Damp Location.
2
2.1
Remove the eight Phillips screws from the top of the driver
housing and pull the cover off to expose the driver wires.
housing
cover
Phillips screw
2.1
3
3.1
Insert the 120-277V AC power into the driver housing from the electrical panel. Followed by bringing 24V DC low voltage conduit one for the LED &
other for the controller wires. Refer to diagram on page 2 to make all the proper wiring connections.
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
[email protected]
www.luminii.com
24V DC, 4.0A
Max. wattage
96 W
1
1.1
LED Driver can be mounted vertically or horizontally. With a
minimum of 2" clearance around LED Driver to provide proper
air circulation.
Before installing, check the label and ensure the LED
Driver has the proper input voltage, output voltage, and
wattage for the job. Check the wire markings to ensure
they match the wiring diagram below. Refer to table
above for the maximum loads!
2” min.
2” min.
2” min.
5.2”
2.6”
13.4”
14.4”
Input
120 - 277V AC, 1.1A, 50/60Hz
Output
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
120-277 VAC
conduit
driver housing
Dali controller
wire conduit
LED wire
conduit
3.1
3.1
3.1
REV0.2 11152018
Page 1 of 2
PLENUM FOR
SUCH USE IN
ACCORDANCE
WITH UL2043
