HOW TO RESET A PROCESS ENGINE
To reset a process engine, follow the following steps:
Hover your mouse over the top left corner of the process engine and select the tick box.
Click on the trashcan icon at the top right corner above the first process engine.
A blank process engine appears as follows:
If you want to reset all the process engines at once, navigate to the top left above the first process engine
and select the tick box “Select all Process Engines”
HOW TO CONFIGURE A PROCESS ENGINE
To configure a process engine, first click on the SELECT MODE label (the centre block of the process
engine), the process engine panel appears.
Click on the icon to select the mode you wish to use. Modes are described in chapter 5 of
this manual.
Forward
, an input is send to an output.
LTP merge
, Latest Takes Precendence with up to four inputs.
HTP merge
, Highest Takes Precedence with up to four inputs.
Backup
, Input 2 becomes active if input 1 is not available.
X-Fade
, Cross-fade between input 1 and input 2.
Switch
, with the use of a control source choose which of the up to four inputs is active.
Custom
, any of the other modes, or combination of, on a channel level.
At any time, you can click on the Patch button , the Master/Limit button , or the Startup Buffer
button to open the relevant configuration panel.
Next, click on the left-hand block, to select your input . According to the selected mode, the number of
inputs may vary. A process engine supports up to four inputs.
Input options are:.
Art-Net
: Select the Art-Net universe to use. You can enter a numeric value between 0 and 32767.
sACN
: Select the sACN universe to use. You can enter a numeric value between 1 and 63999.
KiNET
: KiNETv2, the port number is automatically matched to the number of the process engine.
RTTrPL
, BlackTrax: Select the RTTrPL universe to use. You can enter a numeric value between 0 and
63999.
Internal
, the result of another process engine.
Play
, one of the recorded shows.
You can give your input a name for easy identification.
Next, select your output by clicking on the output block, located on the right-hand side.
Here, you can choose between Art-Net, sACN, KiNET or any combination of the four to send data coming
from the process engine. The four types of output can be used at the same time, providing you with great
flexibility.
Once selected, click on the Save button to store the parameters of your process engine. Your engine is
ready to go!
3 | ConfIGUratIon
13
