READ THESE INSTRUCTIONS
THOROUGHLY BEFORE
INSTALLATION KEEP THESE
INSTRUCTIONS FOR
FUTURE REFERENCE.
IMPORTANT:
This product must be installed
by a qualifi ed electrician or
competent person, and in
accordance with current building
and IET wiring regulations.
• Light Fitting
• Instruction Manual
• Brackets
• Cable Gland
Stanford
Anti-Corrosive
Single & Twin
19W, 27W & 38W Single / 38W, 57W & 72W Twin
IP65
Warranty
5 YR
Hours
50,000
Manby Business Park, Manby, Lincolnshire, LN11 8UT
Lumineux is a B&T Associates Ltd company.
Technical Helpline: +44 (0)1507 328031
www.lumineux.co.uk
1
2
5
3
6
on
off
4
Stanford
Anti-C
orr
osive
1. Route the correct 3-core or 4-core cable type
according to the location of the light fi tting, i.e.
outdoor location requires H05RN-F (1.0mm
2
)
waterproof cable
2. Secure the mounting brackets into position using
suitable wall fi xings and screws according to the
size (LF) of the light fi tting
(1)
3. Release the light fi tting locking clips to remove
the diffuser
(2)
and release the LED gear tray using
the twist-clips, set aside
(3)
4. Fit cable gland (supplied)
5. Thread the cable through the gland and connect to
gear tray terminal as shown depending on fi xture
type
(4)
and tighten the cable gland, refi t the
geartray and diffuser on completion
(6)
6. Switch the mains power on and check the luminaire
illuminates or proceed to microwave and
emergency unit settings
IK08
POWERED BY : ENEC
TOOLS REQUIRED
BOX CONTENTS
• Drill
• Screwdriver
• Cable
INSTALLATION INSTRUCTIONS
on
off
This lighting fi xture has been properly
packed to avoid damage during
transit. Before commencing with the
installation carefully inspect the
luminaire to confi rm there is no
damage. DO NOT INSTALL if any
damage has occurred to the fi xture
or any of its components.
• Turn off the mains power before performing
inspections, installation, or removal
• Verify that the supply voltage is correct by
comparing it with the luminaire label information
• It is the installers responsibility to ensure installation
is suitable for the total load of the luminaire(s). The
supply cable, fuses/circuit brakers must be correctly
rated for the electrical load and considering for any
transient inrush currents that may occur
• Do not perform insulation strength or resistance
tests on installed luminarie(s) connected
PLEASE READ THESE INSTRUCTIONS
BEFORE INSTALLATION.
WARNING: Risk of electric shock! Isolate
the mains power before proceeding.
DD
A
G
Electrical connection wiring
LIVE (SW)
= Brown
NEUTRAL
= Blue
EARTH
= Green/Yellow
