11.00
100.00
220.00
R5.50
11.00
100.00
220.00
R5.50
11.00
100.00
220.00
R5.50
READ THESE INSTRUCTIONS
THOROUGHLY BEFORE
INSTALLATION KEEP THESE
INSTRUCTIONS FOR
FUTURE REFERENCE.
IMPORTANT:
This product must be installed
by a qualifi ed electrician or
competent person, and in
accordance with current building
and IET wiring regulations.
• Light Fitting
• Instruction Manual
• Brackets
Frankly Plus
Floodlights
100W, 150W, 200W, 240W, 300W & 400W
IP66
Warranty
5 YR
Hours
50,000
Technical Helpline: +44 (0)1507 328031
www.lumineux.co.uk
1: Wall
installation
1: Ceiling
installation
1: Ground
installation
2
2
2
on
off
3
3
3
4
4
4
Frankly Plus
Floodlghts
IK08
TOOLS REQUIRED
BOX CONTENTS
• Drill /
Screwdriver
• 8mm Allen Key
• Cable
INSTALLATION INSTRUCTIONS
on
off
This lighting fi xture has been properly
packed to avoid damage during
transit. Before commencing with the
installation carefully inspect the
luminaire to confi rm there is no
damage. DO NOT INSTALL if any
damage has occurred to the fi xture
or any of its components.
Drill two holes in
the wall with an
electric hammer.
Use an electric hammer
to drill two holes in the
ceiling.
Drill two holes in the
fl oor with an electric
hammer.
Use a hammer
to drive the two
anchor bolts into
the previously
drilled holes.
Use a hammer to drive the two anchor bolts into
the previously drilled holes.
Use a hammer to drive the two anchor bolts into
the previously drilled holes.
Loosen gear adjustment screws on left & right
sides, then align the mounting holes of the bracket
with the two expansion screws and tighten.
Loosen gear adjustment
screws on left & right
sides, then align the
mounting holes of
the bracket with the
two expansion screws and tighten.
Loosen gear adjustment screws on left & right sides,
then align the mounting holes of the bracket with
the two expansion screws and tighten.
Tighten mounting bracket screws then adjust
the illumination angle of the lamp. Lock the gear
adjustment screw and connect the power AC
input line on the lamp to the mains. Complete!
Tighten mounting bracket screws then adjust
the illumination angle of the lamp. Lock the gear
adjustment screw and connect the power AC
input line on the lamp to the mains. Complete!
Tighten mounting bracket screws then adjust
the illumination angle of the lamp. Lock the gear
adjustment screw and connect the power AC
input line on the lamp to the mains. Complete!
AC Input
Gear adjustment
screw
AC Input
AC Input
27
0°
AC Input
AC Input
AC Input
Anchor bolts
Anchor bolts
Anchor bolts
• Turn off the mains power before performing
inspections, installation, or removal
• Verify that the supply voltage is correct by
comparing it with the luminaire label information
• It is the installers responsibility to ensure installation
is suitable for the total load of the luminaire(s). The
supply cable, fuses/circuit brakers must be correctly
rated for the electrical load and considering for any
transient inrush currents that may occur
• Do not perform insulation strength or resistance
tests on installed luminarie(s) connected
PLEASE READ THESE INSTRUCTIONS
BEFORE INSTALLATION.
WARNING: Risk of electric shock! Isolate
the mains power before proceeding.
Manby Business Park, Manby, Lincolnshire, LN11 8UT
Lumineux is a B&T Associates Ltd company.
EE
A
G
