10
Model No.: RCK55
Receiver Installation (Continued)
3.9
13. Screw Two 1-1/4” Threaded Studs (supplied with
the ceiling fan) into the Hanger Brackets Two
Tapped Holes (Figure 22).
14. Slide the Receiver up and over the Hanger
Bracket. Press the Receiver against the Ceiling,
holding it in place while installing the Ceiling
Cover in accordance with the instructions in the
Ceiling Fan Owner’s Manual.
15. Install the Optional Luminance Brands Light
Fixture in accordance with the instructions in the
Light Fixture Owner’s Manual. Use the Screws
previously removed in Section 2.1, Step 1 of this
manual.
NOTE: To prevent damage to the receiver, turn “OFF”
the electricity at the wall switch before installing
or removing light bulbs on the ceiling fan or light
fixture.
CEILING
COVER
#8 EXTERNAL
TOOTH
LOCKWASHER (2)
1-1/4"
THREADED
STUD (2)
#8-32 KNURLED
KNOB (2)
Figure 22
WHITE SUPPLY WIRE
BLACK FAN WIRE
RECEIVER
TO 110V
SUPPLY
LISTED GENERAL USE ON/OFF WALL SWITCH OR
OPTIONAL SW605 WALL CONTROL
YELLOW RECEIVER WIRE
**
BLUE RECEIVER WIRE
*
BLUE FAN WIRE
BLACK
SUPPLY
WIRE
WHITE RECEIVER WIRE
BLACK RECEIVER WIRE
BLACK/WHITE
RECEIVER WIRE
YELLOW FAN WIRE
(FROM UPLIGHT)
DOWNROD
MOTOR COUPLER
FAN HOUSING
OPTIONAL
LIGHT FIXTURE
* IF YOUR CEILING FAN DOES NOT HAVE A DOWNLIGHT,
CAP THE BLUE RECEIVER WIRE USING A WIRE
CONNECTOR.
** IF YOUR CEILING FAN DOES NOT HAVE AN
UPLIGHT, THERE WILL BE NO YELLOW FAN WIRE.
IN THIS CASE, CAP THE YELLOW RECEIVER WIRE
USING A WIRE CONNECTOR.
YELLOW UPLIGHT WIRES
(NOT PRESENT ON ALL FANS)
RED & BROWN WIRES - CAPPED
(DO NOT REMOVE WIRE CONNECTORS)
WHITE FAN WIRE
Figure 23
3.10
Complete wiring diagram of Receiver, Supply & Ceiling Fan (Figure 23).
Please call Customer Service at 1-800-777-4440 if you have any questions about installation and
operation of this Accessory.
