Lumenera Lt-C1610, User Manual

Page: 91 / 144

Teledyne Lumenera Lt Series Feature Reference • 85
5.11 Teledyne Lumenera Control Category
Features listed in the description table but tagged as Invisible are usually for third-party software
usage—not typically needed by end-user applications.
Warning: Setting the cameraBootSequence feature to Lucam and resetting the camera will
disable access to the camera via USB3 Vision. The LuCam mode protocol is required for use of the
Lumenera LuCam API – not Sapera LT API. The cameraBootSequence feature only applies to the
Lt-Ux0x-xxxxx and Lt-Ux1x-xxxxx series cameras. See Switching a Lumenera camera from
LuCam mode to USB3 Vision mode and Switching a Lumenera camera from USB3 Vision
mode to LuCam mode for information and methods required to switch a camera mode.
5.11.1 Teledyne Lumenera Control Feature Descriptions
The following table describes the features and values found in the category, as well as the device
version and visibility level (beginner, expert, guru, invisible). The device version represents a
camera software functional level (different from the firmware revision number) and may differ for
each camera sensor. A major device version release is shown in green . The last column also
indicates whether the feature is a member of the DALSA Features Naming Convention (DFNC) or
the GenICam Standard Features Naming Convention (SFNC, tag not shown).
Display Name Feature & Values Description Device
Version
& View
Camera Boot Sequence cameraBootSequence Boot camera as USB3 Vision or LuCam.
Guru
Lucam Lucam Lucam protocol (applicable when using the
Teledyne Lucam API software)
USB3Vision USB3Vision USB3Vision protocol (compatible with Genicam
and USB3 Vision software API)
Camera Reset CameraReset
Resets the camera features to its power-on
default state but does not do a hardware
camera reset.
Beginner