BM16 07
Assembly Instructions
Assembly
Avoid unintentional starting of the machine.
During assembly and for all work on the
machine, the power plug must not be
connected to the mains supply.
Carefully remove all parts included in the
delivery from their packaging.
Remove all packaging material from the machine
and the accessories provided.
Before starting the operation of the machine for
the first time, check if all parts listed in the box
content section have been supplied
Note:
Check the power tool for possible damage.
Before further use of the machine, check that all
protective devices are fully functional. Any
lightly damaged parts must be carefully checked
to ensure flawless operation of the tool. All parts
must be properly mounted and all conditions
fulfilled that ensure faultless operation.
Damaged protective devices and parts must be
immediately replaced by an authorised service
centre.
Assembling the Handle
- Assemble hub of handle assembly(A)
- Raise mortising machine head (A) , to the up
position by turning handle (B) clockwise.
Installing chisel & bit
– Loosen lock screw, shown in Figure .
- Insert chisel bushing (with the hole facing
forward) into the head. Tighten the screw just
enough to hold the chisel in place.
NOTE:
Set the slot in the side of the chisel to the
left or right, NOT to the front or back. This will
allow chips to escape when cutting mortises.
–
Push the chisel up as far as possible into the
head. Then lower the chisel approximately 0.8mm
to 1.6mm, depending on the type of wood being
worked. Tighten the screw to hold chisel in place.
