IN 5/9 plus Manual
Instrument Settings
•
17
4
Instrument Settings
The pyrometers are equipped with a wide range of setting options for optimal adaption to the
required measuring condition and for getting the correct measuring temperature (description of
all available parameters see Chapter
5 Parameter description / settings
).
Basic settings can be done at the pyrometer itself and additional settings can be made via serial
interface and software
InfraWin
.
Settings at the instrument:
The basic settings are emissivity, exposure time, analog
output. These settings can be adjusted at the pyrometer only in offline mode (see
4.2 Online / offline mode (ONL/OFFL)
).
Settings via serial interface:
The pyrometer is equipped with the serial interface RS232
(RS485 on request) and can be used for connection to a PC. With the standard software
InfraWin
(or self written communication software), the following settings can be made
when the pyrometer is set to online mode (ONL): emissivity, exposure time, analog output,
maximum value storage, minimum value storage, reading of the instrument’s internal
temperature, setting of an address for bus control with RS485 interface, setting of the baud
rate, and function for compensating of the off-set of the ambient temperature.
Additionally,
InfraWin
allows you to use the temperature display and analysis features.
4.1
Switches at the Instrument
The
controls / switches
are
located under the rear cover of
the pyrometer and can be
accessed by removing the rear
cover:
1. Disconnect the electrical
connection
2. Unscrew the rear screws with
a 2.5 mm allen screw
3. Remove the cover off, making
sure it remains straight
(without bending or twisting
it).
Note:
Please make sure that the pyrometer is not contaminated while open. Please
reattach cover following adjuments and keep cover closed for permanent use.
Assembling: When reassembling the cover, insert it carefully into the guide pins and then fasten
it with the screws. The connector cable can now be plugged in.
Rear cover
Switches
Locking screw
(allen key,
2.5 mm)
Aligning
support (pin)
for correct
mounting of
the rear cover
Electrical
connection
