Luma Recorders
|
Remote Control
Troubleshooting
If your remote control is not working, first ensure that there are
batteries in the remote control, that they are installed properly (the
polarities are not reversed), and that they still have a charge.
Check that the IR receiver is not obstructed, and the front panel is
not dirty.
You must aim the remote control directly at the IR receiver in the
front panel of the recorder. If you are aiming the remote at the
recorder from an angle, the recorder may not receive the signal.
If you are still getting no response after pressing any button on the
remote, try the following.
1. Right-click the mouse to leave full-screen mode (if necessary).
2. Click on the Settings icon.
3. Click on Configuration.
4. Choose the More Settings tab.
5. Just below the device name is the device number for the
recorder. The default is 255.
6. On the remote control, press the Dev button.
7. On the remote control, press the numeric key(s) for the
recorder’s device number.
8. On the remote control, press the Enter button.
If there is still no response from the remote, contact technical
support.
Summary of Contents for LUM-500-DVR-16CH
