Luma Surveillance LUM-500-DVR-16CH, Technical Reference Manual

Page: 212 / 217

Luma Recorders
|
Local UI Wizard
Jump to Main TOC 212 Jump to Local UI Wizard
Run the Setup Wizard
While the system boots up, you’ll see
a welcome screen. When the recorder
finishes powering up (roughly 30
seconds), a setup wizard guides
you through getting your system
customized and setting up your
cameras.
If the wizard does not appear, that means that the unit has been
previously installed, and whomever installed it deselected this
option. To get the wizard back, log in as the administrator, right-
click to open the menus, then go to
Settings > Configuration >
General . Near the bottom of that page, click Enable Wizard . Then
go to Settings > Shutdown > Reboot to restart your system and
launch the wizard.
When the wizard launches, you first
choose whether you want to run the
wizard each time the system starts
up. If you choose not to, you can
still access all the tools at another
time through the
Settings menu, or
reinstate the wizard as shown above.
We recommend that you disable the wizard; it is liable to cause your
customer confusion if there is a power interruption at the site.
Make your choice and press
Next
, or press
Exit
to leave the wizard
and go directly to the main screen.
We recommend that you do not exit the wizard during installation.
Next, you must log in to the system.
Enter your admin password to
continue. To enter your password,
click on the text box to the right
of the
Admin Password label. The
box highlights yellow and a virtual
keyboard appears. Use the mouse to
type in the password.
If you do not correctly enter your password after three tries, the
wizard automatically closes and places you at the main screen.