Luma Surveillance LUM-500-DVR-16CH, Technical Reference Manual

Page: 183 / 217

Luma Recorders
|
Local Interface
Jump to Main TOC 183 Jump to Local Interface
Email Tab
This section sets the recorder up to send email alerts when desired.
Note that these settings may not be enough: you may need to change
your email security settings to allow your recorder to send email
alerts. Refer to the documentation from your email provider for
further information.
Click Enable Server Authentication at the top of the page if you are
required to do so by your email provider. Below that, enter the user
email account and password for the email account that will be used
to send the alerts. This is needed to log in to the outgoing email
server.
Next, format the sender’s identity and choose the recipients.
Refer to your email provider’s documentation to enter the proper
SMTP server and port, and to see if you need to enable SSL and/or
TLS.
The Sender and Sender’s Address boxes let you edit whom
the message appears to be from. The sender should be Luma
Surveillance Recorder or something similar. The sender’s email
address could be a third party to whom you wish to respond when
such an alert arrives.
You can define up to three people (or distribution lists) to receive
these email alerts, and customize how they receive them. Select a
recipient number in the Select Receivers dropdown, then enter that
person’s name and email address in the fields immediately below.
You cannot enter more than one email address in this box.
Finally, set the email parameters.
Enable Attached Picture sets the recorder to include a photo of the
incident in the email notification it sends. If this has been enabled,
the Interval dropdown sets how often the recorder sends updates
with attached snapshot images to the email address.
Enable Schedule
allows you to limit the times that the recipient gets
alert emails.
When you click this checkbox, you can also click the starburst
immediately below it to view and edit the schedule.
To adjust the schedule, choose the weekday to edit (or pick holiday)
and click any of the time segments and enter new start and stop
times (shown in 24-hour format). All times included in the schedule