Luma Surveillance LUM-500-DVR-16CH, Technical Reference Manual

Page: 157 / 217

Luma Recorders
|
Local Interface
Jump to Main TOC 157 Jump to Local Interface
HDD
This section helps you manage your hard drives.
General
This provides information on all hard drives in the system.
In quota mode, you cannot edit the hard drives’ parameters. Quota
mode is the factory default setting; to change to group mode, go to
the Advanced page, select group mode at the top, then click
Apply .
The system reboots to initialize the new mode.
In group mode (see “Advanced”, below), you can edit the various
drives by clicking the
Edit icon, which opens the edit window
(below).
If a hard drive is connected over a network, you can remove it from
the recorder’s list by clicking the
Delete icon. You cannot delete a
hard drive that is installed in the recorder itself.
At the bottom, click Add to fetch a hard drive that is connected
over the network. Select a NetHDD slot for the drive, select its type,
enter its IP Address, and its NetHDD directory. If you do not know
the directory, you’ll have to use the web interface to find it; see
“NetHDD” on page 127.
To initialize one or more hard drives, select them by clicking the
checkbox to the left of the hard drive label. Click
Init to initialize the
selected hard drive(s), erasing all information on it. Note that this
cannot be undone!
Click Back to return to the settings menu, or Live View to return to
the live page.
Edit Window
Here you can set the hard drive’s property to read/write (normal),
read-only (archive), or redundancy (back-up). You can also set its
group number.
Click Apply when finished.
Advanced
Mode sets the system methodology to allocate hard disk space to
quota mode or group mode. To change the mode, select your desired