74
CHAPTER 5. DATALOGGING
–
For a continuous Scaler count (Scaler time is 0), the LOG button is enabled at all
times.
• For approximately 2 seconds, the LCD will display the Datalog Table index for the
newly saved log data.
Figure 5.1: Displaying Datalog Table Index of 12
• After displaying the Datalog Table index, the instrument will return to the previous
mode of operation.
• The Datalog Table is linear; once the table is full, no further writes will be allowed until
the Datalog Table is erased.
• If an attempt is made to write to a full Datalog Table, a beep will sound and the max-
imum Datalog Table index (1.00 k) will be displayed for about 2 seconds. The instru-
ment will then return to the previous mode of operation.
5.2 Datalogging Operation – Mode 2
Datalogging Mode 2 will allow the user to choose the Location ID (by Location ID Table in-
dex) to store with the logged data.
• When the LOG button is pressed, the current radiation readings and other log data are
temporarily stored.
• In COUNT Mode:
–
With a set count time, the LOG button is disabled until completion of a Scaler
count.
–
For a continuous Scaler count (Scaler time is 0), the LOG button is enabled at all
times.
• The LCD display will show a possible Location ID Table index for the user. The index
will be auto-incremented from the previously used index.
Ludlum Measurements, Inc.
