Ludlum Measurements 25009185, Manual

Page: 52 / 84

46 CHAPTER 4. SETUP MODE
• Hundreds Place (0-9)
• Number of Decimal Places (0, 1, or 2)
• Range (k on/off for cpm, cps, dpm, Bq;
µ
, m or none for R/h and Sv/h)
ð
If the Secondary Units has changed to a value other than that used to previously
set this Alarm Point, the Alarm Point will be reset to 000.
Secondary Count Units and Minimum Display - A short press of ON/ACK to select the value
to adjust, and MODE to adjust the value. Available vallues are:
• Number of Decimal Places (0, 1, or 2)
• Minimum Units depend on the selected Secondary Units. See list below.
Secondary Units Secondary Count Units Available
cps kcps cps c
cpm kcpm cpm c
Bq kBq Bq d
dpm kdpm dpm d
µ
R/h mR/h R/h
µ
R/h mR/h R/h
µ
R mR R
µ
Sv/h mSv/h Sv/h
µ
Sv/h mSv/h Sv/h
µ
Sv mSv Sv
Table 4.6: Secondary Unit Multipliers
Secondary Units COUNT Mode Alarm 1 -
A short press of ON/ACK to select the value to ad-
just, and MODE to adjust the value. Units will be the same as selected earlier with Secondary
Count Units. The ALARM LCD Segment will flash to indicate Alarm 1. Set this Alarm to 000
to disable. Available values are:
• Ones Place (0-9)
• Tens Place (0-9)
• Hundreds Place (0-9)
• Number of Decimal Places (0, 1, or 2)
• Range (k on/off for cpm, cps, dpm, Bq;
µ
, m or none for R/h and Sv/h)
ð
If the Secondary Count Units has changed to a value other than that used to
previously set this Alarm Point, the Alarm Point will be reset to 000.
Ludlum Measurements, Inc.