Ludlum Measurements 25009185, Manual

Page: 24 / 84

18 CHAPTER 2. GETTING STARTED
Extra-Long Press (press and release after two beeps):
• Enables/disables the Auxiliary Communications in conjunction with the Mode button.
• In Count mode with the timer ready, will increment through the available count times.
– User defined.
– 0 (minimum display) or Continuous Count
– 6 seconds (0:06)
– 30 seconds (0:30)
– One minute (1:00)
– Two minutes (2:00)
– 5 minutes (5:00)
– 10 minutes (9:60)
Press and Hold:
• In Count mode with the timer ready, continuing to hold the button after the second
beep will allow the instrument to cycle through the available count times at approxi-
mately one-second intervals.
2.6.3 DETECTOR Button:
The Detector button’s primary function is to switch between available enabled detectors.
Short Press (press and release before one beep):
• Used to select the active detector, as evidenced by the corresponding DET1, DET2,
DET3, or DET4 LED. The instrument saves this setting prior to shutting down (by de-
fault), so it will power up with the same detector setting.
Long Press (press and release after one beep):
• Currently has no effect.
Extra-Long Press (press and release after two beeps):
• Device Menu: When viewing the detector current overload setpoint, this will switch
the display between the live current reading and the set point value.
Ludlum Measurements, Inc.