Quick Release Power Sports Mirror Kit
Installation Guide
Step 2
Install the mirror mount
Build your own mirror system
Fits 7/8” factory handlebars
Straight or J hook style bars
Mirror Kit CONTENTS
Insert mount ( Cam lock) into the bar end.
If the cam does not slide in freely, loosen the lock
by un-winding the lever. Lever should be in the
unlock position during installation. (Fig 5)
12
mm
Cam
Lock
(1)
17
mm
Cam
Lock
(1)
Mirror
(1)
Short
Stem
(1)
Long
Stem
(1)
Elbow
(1)
10
mm
Jam
Nuts
OR
Step 3
Build up your mirror
Using the rest of the components , Build up a mirror style that best
X
3
Tools Required for Installation
Utility knife
Adjustable wrench
Appropriate end cap remover. (Example: Cap screw or Torx)
Drill with a bore bit, (Required for some models)
suits your needs. Example configurations (Fig 6)
Jam nuts should be located on threads to lock each component into
place. See example with Long Stem & Elbow (Fig 7)
Fig
6
NOTE: One cam lock per kit. A 12 or 17 mm diameter based on kit ordered.
Step 1
Same for LH or RH
, Expose bar end
If the factory grip has an end cap, Simply remove
the cap with the appropriate tool.
If the factory grip does not have an end cap and is
finished with a formed rubber end, carefully cut
Fig
1
Jam
nut
(s)
Long
Stem
,
y
away the rubber end using a utility knife.
TO AVOID DAMAGE TO HEATED GRIPS DO NOT CUT
INTO THE BODY OF THE GRIP.
CUT AWAY THE GRIP END ONLY !
Should appear as shown (Fig 1 & 2)
Fig
2
Step 4
Final Assembly
Jam
nut
Elbow
o g Ste
Fig
7
Some manufactures handle bars have an insert or hard plastic end cap (Fig 3)
This is to be removed by drilling out the insert. (Fig 4)
Note: removing the insert or end cap will not damage heated grips. If you are
not sure or capable of drilling out the insert, contact your dealer.
Before
After
Adjust your mirror system to the optimized viewing angle. Tighten
into place. Jam nuts should be tighten using an adjustable wrench.
(Fig 7) To lock the mirror mount ( Cam Lock) into the tube, turn
the lever clockwise until you feel tension or resistance. Pivot the
Lever 90 degrees to lock (Fig 5)
ATV,
Straight
Bar
Example
Example of factory bar That has had the hard plastic end cap drilled out and removed.
NO TOOLS REQUIRED FOR DAILY USE. Simply unlock the lever to remove , transfer from one machine to another, and or stow
the mirror assembly for all season riding or towing Remember to always lock the mirror while in use
Fig
3
Fig
4
Sled
“J”
Hook
Example
the mirror assembly for all season riding or towing. Remember to always lock the mirror while in use.
STOW-N-RIDE, is a patent design owned by Lucerix International Corp. For customer service inquires and assistance please call our toll free number at
800.295.3703 . Standard 1 year manufacture warranty for defect. 100% replacement subject to inspection. This product is not eligible for warranty in the event
of damage caused by usage and or alteration or tampering. This product can not be returned if it has been installed and used. Please contact our customer
service at our toll free number if you any questions regarding a warrantable issue
Corp Office: 2488 Bristol Circle, Oakville, Ont. CANADA. L6H 5S1. WWW.LUCERIX.COM. EMAIL: [email protected]. Toll free: 800.295.3703