2-32 Quick Installation Guide
You also should have received a second package that
includes the WaveACCESS NET antenna and cable kit
you ordered with the system. This kit typically includes
the antenna, antenna cable(s), tension release cable,
female-to-female N-type adapter (if necessary), external
filter (for certain specific antennas in Europe or ETSI
compliant countries), RF cable clamps and a lightning
arrestor (if ordered).
Note: If any of these items are incomplete or missing, you
might not be able to install the WaveACCESS NET SDR132 or
the WaveACCESS NET MDR132. In such cases, please
contact your nearest Technical Support center. Refer to
Chapter 3, Technical Support
for information.
Installation Procedure
The WaveACCESS NET MDR132 and/or SDR132 unit is
placed indoors. It should be placed as close as possible
to the antenna. The installation of the WaveACCESS
NET remote units requires the following steps:
✦
Step 1: Connecting the Antenna to the Remote
Units, below.
✦
Step 2: Connecting to the Computer or Network,
page 2-33.
✦
Step 3: Powering up the Remote Units, page 2-35.
Step 1: Connecting the Antenna
to the Remote Units
The first step is to connect the antenna to the remote
units.
✦
When using a single antenna, connect it to the front
panel connector marked Main, as shown on the
following page.
