1-14 Quick Installation Guide
Antenna Installation Procedure
To install the antennas:
1. Mount the antennas using the enclosed brackets,
following the instructions included with the antenna
and cable kit that you purchased.
2. Align the antennas so that it is pointing directly
towards the other unit in the pair (referred to as
"gross adjustment").
3. Please insure that antenna polarization (horizontal
or vertical) is identical on the receiving and
transmitting ends.
4. Install the WaveACCESS LINK unit as near to the
antennas as possible in order to minimize the cable
length, as shown in the illustration below. If you
require longer cables, please contact your local
distributor to get an extension. Do not attempt to
use cables other than those recommended for use
with the WaveACCESS LINK units as this may cause
the system to malfunction and invalidate your
warranty.
One (or more) 20 ft.
extension cables
Tension release cable
N-type connector
and optional lightning
arrestor
Antenna and
attached cable
