Diagnostic Parameters and Commands
Using diagnostics-related DO commands
MAX Administration Guide
B-31
Because the stored time is off by more than one second, it is adjusted:
SNTP:
x
Diff1=
y
Diff2=
z
Diag Telnet
Description: Displays messages as Telnet connections are attempted or established. The
Telnet protocol negotiates several options as sessions are established, and Diag Telnet displays
the Telnet option negotiations.
The command is a toggle that alternately enables and disables the diagnostic display.
Usage: Enter
diag telnet
at the command prompt.
Example: The following session shows the MAX terminal server establishing a successful
Telnet connection with a UNIX host.
MAX> diag telnet
TELNET debug is now ON
The far-end UNIX host has been contacted:
TELNET-4: TCP connect
For this Telnet session, the MAX unit will support options 24 and 1:
TELNET-4: send WILL 24
TELNET-4: recv WILL 1
The UNIX host will support option 1:
TELNET-4: repl DO 1
The MAX receives a request to support option 3:
TELNET-4: recv WILL 3
The MAX will support option 3:
TELNET-4: repl DO 3
The UNIX host will support option 3:
TELNET-4: recv DO 3
The UNIX host will not support option 24:
TELNET-4: recv DONT 24
The MAX will not support option 24:
TELNET-4: repl WONT 24
The UNIX host will support options 1 and 3:
TELNET-4: recv WILL 1
TELNET-4: recv WILL 3
Ether-Display
Description: Displays the contents of Ethernet packets.